Amt Configuration - Nexcom NEX 980 User Manual

Chapter 3: UEFI Setup Utility
3.3.7 AMT Technology
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main Advanced H/M Monitor
Intel AMT [Enabled]
BIOS Hotkey Pressed [Disabled]
MEBx Selection Screen [Disabled]
Hide Un-Configure ME Confirmation [Disabled]
MEBx Debug Message Output [Disabled]
Un-Configure ME [Disabled]
Amt Wait Timer 0
Disable Me [Disabled]
ASF [Enabled]
[Disabled]
Activate Remote Assiatance Process
USB Configure [Enabled]
PET Progress [Enabled]
AMT CIRA Timeout 0
WatchDog [Disabled]
OS Timer 0
BIOS Timer 0
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Intel AMT
Use this to enable or disable Intel® Active Management Technology BIOS
Extension. The default is [Enabled].
BIOS Hotkey Pressed
Use this to enable or disable BIOS hotkey press. The default is [Disabled].
MEBx Selection Screen
Use this to enable or disable MEBx Selection Screen. The default is [Disabled].
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
Boot Security Save & Exit
Enable/Disable Intel ®
Active Management Technology
BIOS Extension.
Note : iAMT H/W is always
enabled.
This option just controls the
BIOS extension execution.
If enabled, this requires
additional firmware in the SPI
device
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Hide Un-Configure ME Confirmation
Hide Un-Configure ME without password confirmation prompt. The default
is [Disabled].
MEBx Debug Message Output
Use this to enable or disable MEBx Debug Message Output. The default is
[Disabled].
Un-Configure ME
Un-Configure ME without password. The default is [Disabled].
Amt Wait Timer
Set timer to wait before sending ASF_GET_BOOT_OPTIONS.
Disable ME
Set ME to Soft Temporary Disabled. The default is [Disabled].
ASF
Use this to enable or disable Alert Specification Format. The default is
[Enabled].
Activate Remote Assistance Process
Trigger CIRA boot. The default is [Disabled].
USB Configure
Use this to enable or disable USB Configure function. The default is
[Enabled].
30
NEX 980 User Manual