Command/Response Table For Special Function Sis Commands - Extron electronics ISM 482 User Manual

Programmer's Guide, cont'd
Command/response table for IP SIS commands
Command
Set ISM name (location)
Read ISM name (location)
Set GMT/date
The date and time entered should be Greenwich Mean Time (GMT).
Read GMT/date
Set IP address
Read IP address
Read hardware address
Read # of open connections
Set administrator password
Read administrator password
Set user password
Read user password
When the computer is connected to the switcher via the RS-232 link, the Admin and User password
fields are not masked. If a password has been inadvertently changed to an unknown value, you can
look up and, if desired, change a password in this window without knowing the current password.

Command/response table for special function SIS commands

The syntax for setting a special function is
(such as 35 in the first example below),
delay" in the first example below), and # is the execute command. To view a
function's setting, use
Command
Delay times
RGB delay (Triple-Action Switching)
Example:
Read RGB delay
Scaler settings
Output sync format
Example:
Read output sync format
Output polarity
Example:
Read output sync polarity
4-14 Integration Scaling Matrix Switcher • Programmer's Guide
ASCII Command Response
(host to switcher) (switcher to host)
CN Ipn•
Esc X30
CN
Esc X30
CT Ipt•
Esc X31
CT
Esc X32
• CI Ipi•
Esc X33
CI
Esc X33
CH
Esc X35
CC
Esc X36
• CA Ipa
Esc X34 X34
CA
Esc X34
• CU Ipu
Esc X34 X34
CU
Esc X34
# where
X? X?
ASCII Command Response
(host to switcher) (switcher to host)
* *3# Dly
X2 X20 X2
1*35*3# 1Dly35
*3#
X2 X20
* *6# Syn
X2 X7
2*0*6# Syn00
*6#
X2 X7
* *7# Pol
X2 X8 X8
1*1*7# Pol01
*7#
X2 X8
Additional description
X30
X32
The switcher sends the response,
X33
but the host may not receive it.
* # where is the value or variable
X n X? X n
is the function number (such as "set RGB
X?
is the function number.
Additional description
Switching delay of the selected
X20
input to the selected output.
Adjustable in 0.01 second steps
up to 50 = 5.0 seconds. 0 = 0.0
seconds (default), 1 = 0.1
seconds, 2 = 0.2 seconds, and so
on.
RGB delay for output 1 set to 3.5
seconds.
0 = RGBHV (default).
X7
1 = RGBS.
RGBHV signal on output 2.
:Horizontal/Vertical polarity
X8
0 = H–/V–
1 = H–/V+
H–/V+ polarity on output 1.
2 = H+/V–
3 = H+/V+