Service Messages - QMS 2425 Operation Manual

This status message...
WAITING FOR IDLE
WAITING ON INPUT
END JOB?
WARMING UP
When the printer requires service, operation stops and the message
window displays CALL FOR SERVICE followed by the location of the
problem and error number. Have this information available when you
call for service.
Note: A service message sometimes occurs as a result of an unusual
»
combination of events, not because of an actual problem. When the
printer stops and a service message displays in the message window,
turn the printer off and back on. This often clears the service
message indicator and printer operation resumes. Always try this
before making a service call.
Service calls should be placed to the vendor from whom you pur-
chased the printer. If you cannot get service from your vendor, see
appendix A,"QMS Customer Support," for contact information.
means...
An active job is in process.
Access to the menu is not
allowed until the job is
finished.
The compiler is waiting on
incoming data for the first
job in the queue. The job
may not have an end-of-
job indicator and therefore
cannot end. The message
clears if more input arrives
from the port or if you
press the Cancel key. No
other jobs can be printed
until this job has ended.
The printer is warming up.
do this...
Wait until the print
job is finished and
the printer goes
idle.
Wait until the job is
finished and the
printer goes idle to
access the
configuration menu.
Wait until the IDLE
message displays
before printing.