Table of Contents
Advertisement
Chapter 9
WAITING ON
INPUT
END JOB?
WARMING
UP
Service Call Messages
CALL FOR
SERVICE
100K
CHECKUP
REPLACE
FUSER
The 100K CHECKUP and the REPLACE FUSER messages can
be clear ed thr ou gh the Clear War ning option in the
Administration/Engine menu. Then, you can continue to use the
printer. (See "Administration/Engine" in chapter 4 for details on
clearing the warning.)
CAUTION: We strongly recommend that you have the fuser
replaced or the 100,000 copy checkup done as soon as possible
after a message appears. If you clear one of these messages, the
9 - 4
The printer compiler is waiting on incoming data for
the first job in the job queue. It is possible that the job
did not end with an end-of-job indicator and therefore
cannot end by itself. The message is displayed in case
you want to cancel the job or send an end-of-job
indicator. The message disappears if more input arrives
from the port, if the relevant specified timeout elapses,
or if you send an end-of-job indicator. No other jobs
can be printed until this job has ended.
The printer is warming up; the fuser is at a low
temperature. Wait until the printer has warmed up
before you print.
A mechanical error has occurred and a service call is
required. Before calling for service, make a note of the
full message in the message window. See appendix A,
"QMS Customer Support," for information on how to
contact QMS. When a CALL FOR SERVICE x
appears, the printer stops until the required service is
complete.
Approximately 100,000 copies have been printed. It's
time for periodic maintenance and parts replacement to
protect your printer and maintain print quality.
Approximately 60,000 copies have been printed. It's
time to replace the fuser to ensure print quality and
reduce wear on your printer.
T r o u b l e s h o o t i n g
Advertisement
Table of Contents
