Reprogrammable Keys And Commands - GE KTD-405 User Manual

Reprogrammable keys and commands

From the supervisor programming mode you can reprogram any of the soft keys with any of the available
commands.
Note: Holding the seq key for three seconds returns you to the normal operating display, except on displays where esc is
required to exit.
To reprogram soft keys, do the following:
1. Beginning at the normal operating display,
enter the supervisor programming mode by
pressing and holding the
2. After the keypad beeps and the code entry
display appears (Figure 74), quickly enter
the access code for the supervisor menus by
pressing the 1-4-7-6-seq key sequence.
The display will automatically advance to
the next display.
3. Press the key (for NEXT) until the
PROGRAM SOFT KEYS display appears
(Figure 75). Press the + side of the zoom,
focus, or iris key.
Note: Use the plus side of any of these keys for
YES and the minus side of any of these
keys for NO.
Figure 76. Keys that can be reprogrammed
key.
ZONE 32 PA
CAMERA 22
Figure 73. Normal operating display
CAMERA 0
MONITOR 1
Figure 74. Code entry display
ENTER PROGRAMMING
CODE:
Figure 75. PROGRAM SOFT KEYS display
PROGRAM SOFT KEYS?
(+)=YES (-)=NO
Appendix A
Sample configurations and charts
_
NEXT
Recommended set
Complete set
67