Supervisor Programming - GE KTD-405 User Manual

22 KTD-405/KTD-405A Controller Keypad
User Manual

Supervisor programming

As explained in Entering programming modes
PROGRAMMING CODE menu, press 1-4-7-6-seq.
Note: This is the default factory supervisor programming code sequence. After you install your KTD-405 keypad, be sure to
change the supervisor programming code as soon as possible to avoid security problems. To change the programming
code, see Figure 27 on page 26 of this menu. This is a critical number since it is needed to change any of the access
codes. Be sure to store the new number in a safe place. If the number is lost, GE Security technical support can help you
reset the keypad to factory defaults. All keypad setup information will be lost.
1. At the first menu in supervisor programming mode, you have the option to erase the keypad's
nonvolatile memory and reloads factory values. If you chose YES, you have these further options:
RESET ALL. Resets all stored settings to factory default.
RESET ALL BUT TITLES. Retains the zone titles, but sets everything else to factory defaults.
In addition, this screen allows you to reinitialize CyberScout cameras so that they find all of their
orientation points. Access the CyberScout you want to reset before you enter supervisor
programming. CyberDomes are reset from the CyberDome programming menus. Refer to the
CyberDome Programming Manual. Pressing
changing set parameters.
To skip this menu and go to the next, press - or
Figure 17. Supervisor programming menu tree
RESET TO DEFAULTS?
(+)=YES (-)=NO
Note: Only CyberScout cameras are reset (reinitialized) when you select 3. CyberDomes must be reset from the
CyberDome programming menus. Refer to the CyberDome Programming Manual.
NO
NEXT
1 = RESET ALL BUT TITLES
2 = RESET ALL 3 = CAMERA
PARTIAL.
(+)=YES (-)=NO
COMPLETE.
(+)=YES (-)=NO
RESET CAMERA X ?
ARE YOU SURE?
KEYPAD ADDRESS: 99
(01-99)
on page 21, to enter the supervisor menus, from the ENTER
forwards you through programming without
.
ARE YOU SURE?
NEXT
ARE YOU SURE?
NEXT
+,YES -,NO
INITIALIZING DEFAULTS
NEXT PLEASE WAIT