Zone Menus - GE KTD-405 User Manual

Zone menus

Remember that the addressing between domes and multiplexers is offset. When setting up and controlling your
cameras in zone mode, refer to
To program your keypad in zone mode, do the following:
1. Bring up the OPERATING MODE menu
(Figure 38).
2. Select ZONE to displays the zone menu
(Figure 39). This menu enables you to
change the hub device label displayed on the
LCD during normal operation. Label choices
are ZONE, MPLX, DVMR, TERR, BLDG,
FLR, DEPT, STA, SITE, or AREA. ZONE is
the default label.
3. At the ENTER ZONE ADDRESS menu
(Figure 40), pressing
ZONE xx ACCESS menu (Figure 47 on
page 32).
4. Enter a two-digit zone address to display the
ZONE xx TITLE menu (Figure 41). Use the
, , , or
title the zone.
or Moves from a space to A through Z, to
9 through 0.
or Moves from a space, to 0 through 9, to
Z through A.
or Moves the cursor right.
or Moves the cursor left.
Zone titles enable you to identify which zone is being addressed (Building 248, Headquarters,
etc.). A zone title can be up to 15 characters. Titles can include A through Z, 0 through 9, and
spaces.
5. If you have reached the ZONE TITLE menu
through the SUPERVISOR menu and enter or
change the title, you have the option to send
the title to all keypads in the system
(Figure 42). This menu does not appear if
you entered with the USER menu code.
Zone receiver site addressing
takes you to the
keys or move the joystick to
on page 65).
Figure 38. OPERATING MODE menu
OPERATING MODE:
( , )=SELECT
Figure 39. Zone menu
LCD DISPLAY LABEL:
( , )=SELECT
Figure 40. ENTER ZONE ADDRESS menu
ENTER ZONE ADDRESS: 01
(01-32)
Figure 41. ZONE xx TITLE menu
ZONE 01 TITLE:
( , , , )
Figure 42. SEND TO ALL KEYPADS display
SEND TO ALL KEYPADS?
(+)=YES (-)=NO
Chapter 3
Programming
ZONE
NEXT
ZONE
NEXT
NEXT
NEXT
31