Emergency Activation Keys; Keypad Functions; Arming Your System In The "Away" Mode - GE NetworX NX-1600E Series User Manual

Table of Contents

Advertisement

EMERGENCY ACTIVATION KEYS

You must hold these keys for 2 seconds to activate these functions.
system may not be programmed for these activation keys (see page 1). Press
these keys only in an emergency situation that requires response by emergency
personnel.
FIRE
This can activate the fire alarm when pressed for two seconds. If your system is
connected to a monitoring center, an emergency report could be sent to that
center.
AUXILIARY Emergency
This can activate the auxiliary alarm when pressed for two seconds. If your
system is connected to a monitoring center, an emergency report could be sent
to that center.
POLICE (Panic/Hold-Up)
This can sound a local audible alarm when pressed for two seconds. If your
system is connected to a monitoring center, an emergency report could be
transmitted to that center. NOTE: Some Panic/Hold-Up alarms are programmed
to be silent at the protected site while reporting an alarm to the monitoring center.
Check with your installing company to determine how your security system will
respond to the Panic/Hold-Up activation.

KEYPAD FUNCTIONS

ARMING YOUR SYSTEM IN THE "AWAY" MODE

AWAY is used when the user is away from the premise and wants the interior
protected. Listed below are the steps to arm in the AWAY Mode:
Step 1 Close all protected doors and windows.
• Ready light will be on or flashing when all protected zones and
sensors are secure. NOTE: If any zones are bypassed, a sensor
in that zone can be violated without affecting the ready light.
• The security system will not arm if the ready light is not on or
flashing.
• If the power light is off, you have no AC power. Restore power if
possible. If not, contact your installing company for service.
• Enter your 4- or 6-digit user code to arm the system.
Step 2
• The armed light will illuminate.
• You may now leave the building.
Note: The keypad will beep rapidly during the exit delay. The user
may wish to disarm and re-arm the system if more time is needed.
6
1
3
Press
+
4
6
Press
+
7
9
Press
+
together for 2 seconds.
together for 2 seconds.
together for 2 seconds.
NX-1600E LCD Keypad
Your

Advertisement

Table of Contents
loading

Table of Contents