Entering Programming Modes - GE KTD-405 User Manual

Entering programming modes

To enter programming mode, do the following:
1. When you provide power to the unit, the
normal operating display appears
(Figure 15).
2. Press and hold the
tone and see the ENTER PROGRAMMING
CODE menu appears (Figure 16).
Note: The ENTER PROGRAMMING CODE menu
times out after five seconds.
3. Enter your programming code:
• Supervisor:
• User:
• Remote device:
Note: These access codes can be changed by the installer or administrator. They will tell you the new codes if your are
allowed access to the menu. Menus time out after four minutes. Menus that were not implemented in this release are
indicated by two beeps and a message that reads NOT IMPLEMENTED.
key until you hear a
Press 1-4-7-6-seq and see
Press 5-7-9-seq and see
Press 9-5-1-seq and see
Figure 15. Normal operating display
CAMERA 0
MONITOR 1
Figure 16. ENTER PROGRAMMING CODE menu
ENTER PROGRAMMING
CODE:
Supervisor programming
User programming
Remote programming
Chapter 3
Programming
on page 22.
on page 28.
on page 34.
21