Processor - Intel SE7500CW2 Product Manual

Processor

The Server Board SE7500CW2 accommodates two Intel Xeon processors with 512 KB cache. The
SKT604 is a 604-pin zero-insertion force (ZIF) socket. The processor(s) interface with the system
bus at 400 MHz.
For a complete list of supported processors, see:
http://support.intel.com/support/motherboards/server/SE7500CW2
Dual Processor Operation
The Intel Xeon interface is dual processor (DP) ready. Each processor contains a local
®
Intel Advanced Programmable Interrupt Controller (APIC) section for interrupt handling. When
two processors are installed, both processors must be of identical revision, core voltage, and
bus/core speeds.
Boxed Processor Fan Heat sink
A processor wind tunnel is supplied with the boxed Intel Xeon processor. After the processor and
heat sink are installed, install and connect the processor wind tunnel. For proper processor cooling,
the fan inlet air temperature should be below 45 °C.
CAUTION
Clearance is required at each end of the fan heat sink to ensure unimpeded
airflow for proper cooling. Restricting the airflow through the processor heat
sink can cause overheating and subsequent failure of the processor.
Description 11