Attaching the Label to the I/O Shield
1. Remove the backing from the label included with your server board.
2. Press the label onto the outside face of the I/O shield. See Figure 4, A.
Installing the I/O Shield
1. Position one edge so that the dotted groove is outside the chassis wall, and the lip of the shield
rests on the inner chassis wall.
2. Hold the shield in place, and push it into the opening until it is seated. Make sure the I/O shield
snaps into place all the way around.
Server Board Installation
A
Figure 4. Attaching the Label to the I/O Shield
Figure 5. Installing the I/O Shield
OM14360
1
2
OM14427
51