Installing The Optional Scsi Add-In Card - Intel SE7500CW2 Product Manual

Installing the Optional SCSI Add-in Card

Certain versions of the Server Board SE7500CW2 ship with an Ultra160 SCSI card. This card has
the following features:
•
Ultra160 single channel based on the LSI
•
PCI 2.2 compliant
•
PCI 64-bit/66 MHz
•
Universal PCI form factor
•
Low profile form factor, shipping with a full-size bracket attached and a low-profile bracket in
the packaging
•
Internal and external connectors (internal standard 68 pin HD, external VHDI connector)
•
Termination: Universal (LVD/SE) termination, automatic cable detection, software disable
•
Four-pin header for off-board LEDs
Drivers for this card can be downloaded from the Server Board SE7500CW2 System Resource CD
that ships with the board or from the Server Board SE7500CW2 Intel Support Web site:
http://support.intel.com/support/motherboards/server/SE7500CW2
✏
NOTE
In order to maximize airflow within the chassis, it is recommended that you
install the SCSI add-in card in either PCI slot 2 or 3 and install SCSI devices
in the chassis lower device bays. However, the SCSI add-in card can be
installed in any PCI slot on the server board.
1. Remove the screw that secures the filter panel at PCI slot 2 or 3.
2. Remove the filter panel at PCI slot 2 or 3 by pushing it out from the inside of the chassis.
3. Insert the SCSI card.
4. Replace the screw.
60
†
53C1000 SCSI controller
Intel Server Board SE7500CW2 Product Guide