Changing The Bios Language - Intel SE7500CW2 Product Manual

1. Obtain the BIOS update file package from http://support.intel.com.
2. A file called "crisis.zip" is one of the files included with each Server Board SE7500CW2 BIOS
release file package. Unzip the "crisis.zip" file to a directory on your hard drive.
3. Format a blank diskette (the diskette should not be a bootable DOS diskette). Insert the diskette
into the diskette drive.
4. From the MS-DOS
directory you created on your hard drive. Follow the instructions on the screen to create the
BIOS recovery diskette.
✏
NOTE
The BIOS recovery diskette will not be created correctly under the MS-DOS
window of a Windows operating system. It is necessary to use an MS-DOS
system to create the BIOS recovery floppy diskette.
5. Power off the system, unplug the power cord, and remove the chassis panel.
6. Remove the spare jumper from pins 9-10 on jumper block J106 and install it on pins 1-2 (BIOS
Recovery) of jumper block J106.
7. Insert the BIOS recovery diskette into the diskette drive.
8. Reinstall the chassis panel, plug in the power cord(s), and power on the system.
9. The screen will remain blank while the BIOS Recovery is performed. A number of beeps will
occur during the BIOS update. The diskette drive access light will not turn off when the BIOS
recovery is completed. Allow four minutes for the BIOS recovery to complete. If a POST card
is installed in a PCI slot during the BIOS recovery, you can tell that the BIOS recovery is
complete when code "EC" is displayed. When the BIOS Recovery is complete, it is safe to
power off the system.
10. Power off the system, unplug the power cord(s), and remove the chassis panel.
11. Remove the BIOS Recovery jumper from pins 1-2 and store the jumper on pins 9-10.
12. Replace the chassis panel, plug in the power cord(s), and power on the system.
13. Perform a CMOS clear following the BIOS recovery.

Changing the BIOS Language

You can use the BIOS upgrade utility to change the language the BIOS uses for messages and the
Setup program. Use a bootable diskette containing the Intel flash utility and language files.
1. Boot the computer with the bootable diskette in drive A. The BIOS upgrade utility screen
appears.
2. Select Update Flash Memory From a File.
3. Select Update Language Set. Press <Enter>.
4. Select drive A and use the arrow keys to select the correct
5. When the utility asks for confirmation that you want to flash the new language into memory,
select Continue with Programming. Press <Enter>.
6. When the utility displays the message upgrade is complete, remove the diskette. Press
<Enter>.
7. The computer will reboot and the changes will take effect.
44
†
prompt on an MS-DOS system, run the "crisdisk.bat" file from the
lng file. Press <Enter>.
.
Intel Server Board SE7500CW2 Product Guide