Routine Cleaning - Fujitsu SCALEOVIEW S17-2 Operating Manual

Special Maintenance Instructions
• Do not spray the cleaner or rinse water onto or into the card reader, receipt printer, cash
acceptor, or electronic display areas of the unit.
• Nu Finish is the recommended polish. Do not use any wax-based polishes.
• Do not apply the Nu Finish polish to electronic displays or nozzle boots.
• Do not use pressure washers or high pressure hoses. Rinse water must be applied as a
gentle spray.
• Do not use high pressure hoses.
• DEF is mildly corrosive with metals. Do not allow dried or wet DEF to remain on metallic
parts on or near the dispenser for more than a day.

Routine Cleaning

Perform the following routine cleaning weekly or as required:
Place safety cones or other devices to barricade the units being cleaned.
1
Wear safety glasses and flexible rubber gloves.
2
In the empty spray bottle, prepare a mixture of one (1) part Concentrated Simple Green cleaner
3
to 10 parts water.
CAUTION
Do not spray the cleaning mixture and water in or onto the card reader, receipt
printer, cash acceptor, or electronic display area, as it may damage the equipment
and will not be covered by warranty.
Spray the prepared cleaning mixture on the unit from bottom to the top. Streaking may occur if
4
sprayed from the top down.
Scrub the unit with a soft bristle nylon brush in a circular motion from bottom to top. Scrub
5
long enough to cause the cleaning solution to foam. For best results, two scrubbing cycles are
recommended.
Rinse the unit thoroughly from the top to the bottom, ensuring that all the cleaner is removed.
6
For best results, brush the unit when rinsing. Cleaner that dries on the unit will attract dirt.
Dry the unit with a clean white cloth.
7
Remove barricade(s) and cleaning supplies from the unit area.
8
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Maintaining Units
Page 63