Cleaning The Crind Device In The M00317A00X Printer; Clearing Paper Jams In Usb Printer (M04119A001) - Fujitsu SCALEOVIEW S17-2 Operating Manual

Periodic Maintenance Requirements

Cleaning the CRIND Device in the M00317A00X Printer

Clean the CRIND device in the M00317A00X printer using printer cleaning cards (Q13400)
every three months. Cleaning the printer will eliminate most print quality problems.
To clean the CRIND device's printer, proceed as follows:
Remove the paper and paper roll from the printer. Follow the instructions in
1
Receipt Paper in the M00317A00X Printer"
Insert a printer cleaning card into the inlet.
2
Manually advance the cleaning card through the roller bars using the round feed knob near the
3
paper release lever.
Replace the paper roll and re-install the receipt paper. Follow the instructions in
4
Receipt Paper in the M00317A00X Printer"

Clearing Paper Jams in USB Printer (M04119A001)

CAUTION
Avoid using tools for prying printer parts or using excessive force to clear jams.
This could result in permanent damage to the printer.
To clear a paper jam, proceed as follows:
Pull the right blue pin and lift the Printer Control Module to expose the jam.
1
Note: In Encore S series units, the printer is installed in an inverted manner. Hence, pull the
Figure 5-26: Printer Control Module
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
left blue pin to lift the Printer Control Module and expose the jam.
on page 45 (steps 1 to 4).
on page 45.
Printer Control Module
Right Blue Pin
Maintaining Units
"Changing the
"Changing the
Page 59