Operating The Units; Console Mode (Two-Wire); Standalone Mode - Fujitsu SCALEOVIEW S17-2 Operating Manual

Operating the Units

Operating the Units
The Encore and Eclipse units can dispense fuel in one of the following two modes:
• Console mode (Two-wire) - Authorization and payout occurs at the console
• Standalone mode - Authorization and payout occurs at the pump
This section provides instructions for operating the units in either mode.
Note: For the location of components, refer to the illustrations in

Console Mode (Two-wire)

Consoles can be set up in a pre-authorized mode where a sale is automatically allowed, or in
an authorization mode where a sale requires initiation by a cashier.
To operate a unit in authorization mode, proceed as follows:
Note: Step
Authorize the unit at the console.
1
Remove the nozzle and lift the pump handle, if required.
2
Select the grade and/or payment form, if required.
3
Dispense the fuel.
4
Return the nozzle to the nozzle boot.
5
Pay out the fuel transaction at the console.
6

Standalone Mode

Standalone mode does not involve the console with the sale. To operate a unit in a
pre-authorized mode, proceed as follows:
Remove the nozzle and lift the pump handle, if required.
1
Select the grade and/or payment form, if required.
2
Dispense the fuel.
3
Return the nozzle to the nozzle boot.
4
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Eclipse Series" on page 7.
1 can occur before or after steps
Introducing the Encore/Eclipse Series
"Introducing the Encore/
2 and 3.
Page 19