Fujitsu SCALEOVIEW S17-2 Operating Manual page 53

Periodic Maintenance Requirements
To replace the receipt paper in the USB printer, proceed as follows:
Remove the paper roll core.
1
Note: To prevent paper from being trapped inside the printer, the printer automatically
Figure 5-10: Paper Removal
Note: In Encore S series, the printer is installed in an inverted manner, as you open the printer
Figure 5-11: Printer in the Encore S Series Unit
Locate the paper removal trigger on the left-hand side of the printer. This is located directly
2
under the "Remove Paper" trigger decal. For the exact location of the trigger, see
on page
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
reverses the last short receipt left from the paper roll. Remove such receipts along with
the paper roll core, if present.
door as shown in Figure
procedure for changing the receipt printer paper remains as explained in this section.
50.
Paper must be removed properly to
prevent paper jamming.
5-11. Apart from the way in which the printer is installed, the
Printer Control Module
Maintaining Units
Figure 5-12
Page 49