Fujitsu SCALEOVIEW S17-2 Operating Manual page 44

Maintaining Units
Recommended
Frequency
After first filter
change—Every
300,000 gallons
(1.1 million
liters), every six
months, or when
fuel delivery rate
significantly
slows.
Every three
months
Every three
months
Every six months Inspect and
Page 40
Components Recommended Maintenance
WARNING
Do not attempt to perform any of these tasks yourself.
Performing these tasks incorrectly could result in severe injury
or death.
Note: Most complaints regarding continual slow flow rate from the dispenser are
caused by clogged filters
Clean CRIND • Clean the CRIND device M00317A00X printer
device printer using the printer cleaning card Q13400. Follow
instructions in
the M00317A00X Printer"
Moore Wallace M05194B001).
• Clean the CRIND device M04119A001 (USB)
printer using the M05194B001 cleaning kit.
Follow instructions included in the kit.
Clean CRIND Clean the CRIND device display regularly with a
device display mild detergent and soft cloth using Moore Wallace
M05194B001 cleaning kit. Be careful not to scratch
the display. Do not use an abrasive cleaner, or glass
cleaner or detergent that contains ammonia.
Ammonia will damage plastic display windows and
door materials.
To check valve operation, perform the following
lubricate tasks:
Shear Valves 1. Trip the valve.
2. Authorize the hose at the console, if required.
3. Lift the operating handle.
4. Place the discharge nozzle in an approved
container.
5. Squeeze the nozzle operating lever. If flow
continues after several seconds, the valve is
defective and must be serviced or replaced.
6. Place a few drops of SAE10 oil on Shear Valve
body shaft.
7. Open and close valve with a wrench several
times.
8. Place valve back in service.
Note: If repair is required, call an ASC/CSC.
CAUTION
If you are not sure which device is the Shear Valve or have not
been trained regarding its use or service, have the ASC/CSC
inspect and lubricate this device for you.
WARNING
Do not attempt to make these repairs yourself. Doing so could
result in severe injury or death.
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
CAUTION
"Cleaning the CRIND Device in
on page 59 (use
CAUTION
Periodic Inspections
Who Performs the
Inspection/Repair
Owner
Owner
• Owner—Inspect and
lubricate
• ASC/CSC only—Repair