Fujitsu SCALEOVIEW S17-2 Operating Manual page 38

Maintaining Units
Recommended
Frequency
Once a month
Upon receiving a
customer
complaint
Upon receiving a
customer
complaint
Once a week
Page 34
Components Recommended Maintenance
Belts Recommended Belt Tensions:
Tighter belt tensions can cause wear and premature
failures for both pump and motor bearing. Loose
belts result in low flow or pulley/belt failures. Use the
following ratings:
• 65-75 lbs (30-34 Kgf) for new belts
• 50-65 lbs (28-30 Kgf) for old belts
CAUTION
1. On the link belts, check all tabs for correct
positions (inward).
2. Check the belt tension. If there is more than one
inch of play on one side of belt, then tighten the
belts by tightening the idler pulley against the belt.
If there is excessive play, then replace the belt
with the next shorter length belt
1
1
Replacing Refer to the instructions in
printer paper Paper in the M00317A00X Printer"
"Changing the Receipt Paper in USB Printer
(M04119A001)"
Receipt Paper in USB Sliding Printer
(M06972A001)"
Receipt Paper in USB Sliding Printer for Encore S
Series Enhanced Bezel (M07885A001)"
Correcting Refer to the instructions in
printer jams USB Printer (M04119A001)"
Paper Jams in USB Sliding Printer (M06972A001)"
on page 61.
Displays 1. Inspect displays for proper reading of all digits.
2. Verify if the displays are properly backlit.
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Belts and pulleys can pinch fingers and hands.
Injuries may result. Avoid placing fingers or hands
between belts and pulley. Never turn power on to fit
belt on pulley.
"
"
"Changing the Receipt
on page 45
on page 48 or "Changing the
on page 51 or "Changing the
on page
"Clearing Paper Jams in
on page 59 or "Clearing
Periodic Inspections
Who Performs the
Inspection/Repair
• Owner—Inspect
• ASC/CSC only—Repair
and test
Owner
or
55.
Owner
• Owner—Inspect
• ASC/CSC only—Repair
and test