Displaying Pump Totals For Encore/Eclipse Units - Fujitsu SCALEOVIEW S17-2 Operating Manual

Introducing the Encore/Eclipse Series

Displaying Pump Totals for Encore/Eclipse Units

You can view pump totals for Encore and Eclipse units on the main and Price Per Unit (PPU)
displays by using the Manager's Keypad located behind the Customer Interface Module (CIM)
door or Oven door on Side 1 of the dispenser. The keypad's magnetic backing allows easier
handling and input.
Notes: 1) For Encore 300/500/550 and Eclipse units, to identify Side 1 (A) of the pump or
The Manager's Keypad is as shown in
Figure 3-7: Manager's Keypad
1
4
7
CLEAR
Manager's Keypad
Note: To enter the Command Codes required to place the pump/dispenser in Standalone
To avoid potential electric shock, do not touch any wiring or electronic component(s)
behind the CIM/Oven Door or Main Door.
The following table explains how to access the Manager's Keypad.
For this Model Series
Encore 300/500/550/S Series
Eclipse
Page 16
dispenser, refer to the section titled "Programming Orientation" in MDE-4732
Encore and Eclipse Series Owner's Programming Manual.
2) For Encore S Series units, to identify Side 1 of the unit, see
2 3 F1
5 6 F2
8 9
$
TOTAL
0 VOL
ENTER
TOTAL
mode or to program prices directly at the unit, refer to
page 19.
WARNING
Use these Steps to Locate the Manager's Keypad
• Open CIM door on Side 1 (A)
• Keypad is attached (by magnet) behind the door
• Open Oven door on Side 1 (A)
• Keypad is attached (by magnet) behind the door
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Figure 3-7.
"Standalone Mode"
Common Functions
Figure 3-3 on page 9.
on