Introducing The Encore/Eclipse Series; Encore 300 And Encore 500 - Fujitsu SCALEOVIEW S17-2 Operating Manual

Encore 300 and Encore 500

3 – Introducing the Encore/Eclipse Series
This chapter provides illustrations of the Encore and Eclipse units and their components. Refer
to this chapter when you perform the procedures in this manual.
Encore 300 and Encore 500
The Encore 300 and 500 units, which are similar in appearance are shown below. However,
each series has its own hardware/software package. For information on programming the unit,
refer to "Programming Encore 300" in MDE-4732 Encore and Eclipse Series Owner's
Programming Manual. All options may not be available on your unit.
Figure 3-1: Encore 300 and Encore 500 Units
Serial Number Label (on
Units manufactured after
January 2003) is found
inside the CIM
Main Display
CIM Door Lock
Recommended Location
of Static Electricity
Warning Label
CRIND Display
Card Reader
Cash Acceptor
CRIND Keypad and
Optional PPP
CRIND Device Printer
Door Lock
Lower Panel
Shear Valves and Unions behind
Lower Panel (not shown)
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Manager's Keypad (not
shown) can be found
behind the CIM door.
$ $
Serial Number Label (on Units Manufactured before January 2003)

Introducing the Encore/Eclipse Series

Breakaway
Available but not
shown:
- Totalizer Option
- TRIND Option
- Scanner Option
Location of Label for
Approved Vapor Recovery
(VR) Nozzles and Federal
Communications Commission
(FCC) Label
PPU Display and Grade
Select Buttons
$
Boot Area
Nozzle
Pump Handle (Lift to Start
Handle Units)
Swivel
Hose
Brand Advertising Panel
Page 7