Gaining Access to Memory Modules
Figure B-9
1 NEM
2 Front panel
3.
Use two of the saved coverplate screws to fasten the NEM to the DFE module front
panel, but do not tighten screws at this time.
4.
Insert the saved standoff through the NEM to the standoff on the main board. Screw
in the standoff, but do not tighten screws at this time.
5.
Tighten the two coverplate screws first, then the standoff.
B-12 Mode Switch Settings and Option Installations
Installing the Network Expansion Module
Á
Ä
3 NEM connectors
4 Main board connectors
À
Â
Å
Ã
5 Coverplate screws (2)
6 Standoff