PoE Port Status LEDs
The PoE port status of each 10/100 Mbps front‐panel port is indicated by the two‐color RX
and TX LED display for each port. To observe the PoE port status indications, you must
switch the DFE module management system from the default RX/ TX Status Mode to the
PoE Port Status Mode using the DFE module front‐panel GROUP SELECT switch. The
switch operation and a description of how to use the LED indications are described in
"Using LANVIEW" on page 4‐1.
Table
C‐2 provides a brief description of each port status RX/TX LED display.
Table C-2 PoE Status LED Indications
PoE Port Status
Port is powered on
Port is off due to overload
Port is off due to power management
Port is off for other reason
RX LED
GREEN
OFF
RED
OFF
DFE-Platinum Series Hardware Installation Guide C-3
Overview
TX LED
OFF
RED
OFF
OFF