New Poe(Power Pass-Through), Model P6Kp8-Rj45, 10/100Mb 8-Port; Six-Port "4 + 2" Combo Modules,100Mb Fiber - GarrettCom Magnum 6K16-Series Installation And User Manual

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)
or 100Mb speed and full- or half-duplex mode per-port as per user requirement. (See
Magnum MNS-6K Software Manual for details info.).
2.2.4 New PoE(Power Pass-through), model P6KP8-RJ45 (MDIX), 10/100Mb 8-
port
The PoE (Power-pass-through) RJ-45 ports act similar to regular RJ-45 ports,
except they have capability of providing power on each port to power up the PD devices,
6KP8 -45RJ
8 Port@ 10/100Mb Copper ports
1 3
10/10
F/ H
2 4
10/10
F/H
/
LK ACT
1
2
LINK
4
3 PoE
available with mix –n-match with fiber modules. Please check the ordering information
Sec.1.2 for all the various P6K PoE modules option.
The LEDs on 6KP8-RJ45- PoE module are slightly different compared to
regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the
PoE LED is ON when connected properly to a 803.af compliant PD device on that port.
When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data
traffic is not affected by PoE.
LINK and ACTIVITY LEDS are combined on the PoE modules into one LED
that is marked as LINK/ACT, as shown in the diagram.
2.2.5 Six-Port "4 + 2" Combo Modules, 4@ 10/100 RJ-45 and 2@
100Mb fiber
The combo six-port modules are combinations of copper and fiber media, available as
four 10/100 switched RJ-45 copper ports and two 100Mb switched multi-mode fiber ST,
1
10/100
F/H
ACT
F/H
2 TX LK
SC or single mode SC or Long Reach SC ports. For ports numbering, ports 1,3,5,7 are
copper, ports 2 and 6 are fiber, ports 4 and 8 are not present.
www GarrettCom com .
5
LK/AC
POE
6
LK/AC
POE
10/10
FULL/HALF
3 5 7
ACT
F/H
TX LK RX
RX 6
.
2
1
4
3
1
LK
10/100
ACT
F/H
ACT
F/H
2 TX LK
15
per the IEEE802.3af PoE
standard. The Power Pass-
through PoE modules are
totally dependent upon the
powerful -48VDC input
power supply to support
more RJ-45 (10/100)
ports. Each port requires
atleast 15watts to power
up the PoE PD devices.
Maxm. one PoE modules
can be configured in the
A, B slot of any 6K16 s
with -48vdc power input.
The PoE modules are also
3 5 7
ACT
F/H
TX LK RX
RX 6
LK
ACT