New Poe(Power Pass-Through), P6Kp8V-Rj45 (Mdix), 8-Port - GarrettCom Magnum 6K16-Series Installation And User Manual

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)
shielded twisted pair (STP) cable connections. The 6KP8-RJ45 module is equipped with
a Media Dependent Auto-Crossover (MDI-X) switch, which controls all ports for
cascaded connection. This feature eliminates the need for a special twisted pair crossover
cable when connecting to a hub or another switch.
Each port has an Activity (ACT) LED indicating packets being received, a
Link (LK) LED that indicates proper connectivity with the remote device when lit, a
FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off), and a
"10/100" LED indicating 100Mb when lit (or 10 Mbps when off).
Important Note: The 10/100 RJ-45 ports are supported with Auto-negotiation and
Auto-crossover (MDIX), which allow the RJ-45 ports to automatically Link with any RJ-
45 device and eliminate the use of cross-over cable.
5.2.10 New PoE(Power Pass-through), model P6KP8V-RJ45 (MDIX), 10/100Mb
8-port
The PoE RJ-45 ports act similar to regular RJ-45 ports, except they have
capability of providing power on each port to power up the PD devices, per the
6KP8-45RJ
8 Port@ 10/100Mb Copper ports
1 3
10/10
F/ H
2 4
10/10
F/H
/
LK ACT
1
2
LINK
4
3 PoE
POE module are also available with mix –n-match with fiber modules. Please check the
ordering information Sec.1.2 for all the various P6K PoE modules option.
The LEDs on 6KP8-RJ45- PoE module are slightly different compared to
regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the
PoE LED is ON when connected properly to a 803.af compliant PD device on that port.
When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data
traffic is not affected by PoE.
LINK and ACTIVITY LEDS are combined on the PoE modules into one LED
that is marked as LINK/ACT, as shown in the diagram.
PoE LEDs Summary
•
For PoE devices, each RJ-45 PoE port supports only 802.3af complaint
devices. The PoE LED is ON when the attached PD is drawing power from the
www GarrettCom com . .
5
LK/AC
POE
6
LK/AC
POE
10/10
FULL/HALF
2
1
4
3
53
IEEE802.3af PoE
standard. The Power
Pass-through PoE
modules are totally
dependent upon the
powerful -48VDC
input power supply to
support more RJ-45
(10/100) ports. Each
port require atleast
15watts to power up the
PoE PD devices. In this
Fig. the top 8-RJ45
ports are enhanced with
POE option The 8-RJ45