If you do not hear a click as each end of the memory module snaps into the metal tabs, remove
the memory module and reinstall it.
NOTICE: After installation, if the memory module cover does not fit or is difficult to
close, you may have installed the memory module improperly or into the wrong slots.
Remove the memory modules and reinstall them. Do not force the memory module
cover to close because you may damage your computer.
10. Replace the memory module cover as follows:
a. Set the memory module cover loosely over the opening, aligning the three tabs on the
memory module cover to the corresponding slots on the opening. These tabs are on the
opposite side of the cover from the screw holes.
b. Rotate the cover down and reinstall the screws.
11. Reconnect your computer and devices to their electrical outlets and turn them on.
As the computer boots, it detects the presence of additional memory and automatically updates
the system configuration information. Verify that the correct memory total is displayed. If
necessary, repeat steps 1 through 9 until the memory total is correct
Back to Contents Page