Panasonic KX-TA624 Installation Manual page 127

4.1 Before System Programming
To enter the programming mode
Set to "PROGRAM" on
the back of the telephone.
! • The system password can be changed by program [002] "System Password".
!
• During the programming mode, your extension is treated as a busy extension.
• If you enter the wrong system password, you will hear an alarm tone (3 beeps). Try
again.
Programming sequence
After entering the programming mode
X
Enter the Program Address. Enter the parameters.
After pressing the STORE button, you will hear one of the following tones.
Confirmation tone (1 beep):
Alarm tone (3 beeps):
To exit the programming mode
Set to "SET" on the back
of the telephone.
MEMORY
SET PROGRAM
Press
X X
parameters
(2 beeps):
MEMORY
SET PROGRAM
system password
#
#. Enter the system password.
(default : 1234)
STORE
Press the
STORE button.
This informs you that storing is completed. You can
continue programming by entering the same or another
program address
This informs you that the same parameter has already been
stored.
This informs you that the entry is invalid.
END
Press the END
button.
System Programming
4-3