Compaq AlphaServer 160 User Manual page 155

Table 8–1 SCM Commands (Continued)
Command
Set modem_baud
Set dial
Set local_baud
Set com1_baud
Set hp_count
Set hp_qbb_maskx
Set init
Set password
Show csb
Show fru
Show nvr
Show status
Show system
Test alert
Description
Sets the modem baud rate.
Sets the string to be used by the SCM to dial out
when an alert condition occurs.
Sets the baud rate of the SCM-to-local console
device UART.
Sets the baud rate to the SCM-to-system UART.
Defines the number of hard partitions in system.
Sets a value that creates a binary mask in which a
bit set to 1 indicates that a QBB belongs to a
partition x.
Assigns the modem initialization string
appropriate for the dial-out modem at the system
site.
Defines the password to be used by the remote
user when dialing into the system.
Displays a list of all known nodes on the console
serial bus.
Displays information on field-replaceable units
(FRUs).
Displays additional nonvolatile environment
variables.
Displays SCM status and information.
Displays an overall system summary, including
the most recent system self-test results and the
current temperature and voltage readings.
Tests the modem setup and connection to the
remote pager or computer.
Using the System Control Manager 8-15