Removing The Media ,X Axis. Motor - HP 200 Service Manual

Removing the Media ,X Axis. Motor

E Remove the electronics enclosure
cover D page 6 5.
F Remove the window D page 6 15.
G Remove the center cover D page 6 16.
4 Remove the right endcover D page 6 19.
5 Remove the front panel
assembly D page 6 32.
N Remove the carriage motor D page 6 35.
SO OLOGOHOGOF
In the following stepsA take care not to
cut yourself on the encoder stripD
8 Remove the two screws that secure the
drive roller gear to the drive roller
shaft.
Torx-10
C3187 90000
7 Disconnect the media motor cable from
the main PCA (connector labeled X) and
from the uppermost ferrite holder on the
right hand side of the plotter.
Paper-motor
connector
9 Remove the drive roller gear from the
drive roller shaft.
The gear may be stiff t rem ve
Reassembling: Push the gear nt the
shaft as far as it will g
n the gear with the h les n the shaft
Removal and Replacement
Align the h les
6 37