Removing The Pinch Arm Sensor - HP 200 Service Manual

Removing the Pinch Arm Sensor

1 Remove the electronics enclosure
cover ' page 6 5.
2 Remove the window ' page 6 15.
3 Remove the center cover ' page 6 16.
4 Remove the right endcover ' page 6 19.
6 Remove the two screws that attach the pinch arm sensor to the right sideplate.
Torx-10
7 Lift the pinch arm sensor, with cable, clear of the plotter.
C3187 90000
5 Disconnect the pinch arm sensor cable
connector from the main PCA and from
the ferrite on the right sideplate.
The fe i e h lde en f m he
Pinch-arm-
sensor connector
Reassembling: The cable g e h
fe i e indica ed in he diag am bel w
É É É É
KEEP THIS AREA
É É É É
FREE OF CABLES
Ferrite
Pinch-arm
sensor
Removal and Replacement
gh he
6 23