8 Loosen the right screw and remove the
left screw that attaches the stepper
motor to the left sideplate.
Torx-10
Remove
C A U T I O N
Reassembling: Do not cross thread or
over tighten the screws.
6 22
Removal and Replacement
9 Move the stepper motor toward the rear
of the plotter.
Loosen
10 Pull the stepper motor cable gently out
from the electronics enclosure, through
the hole in the left side of the electronics
enclosure, and lift it and the stepper
motor clear of the plotter.
C3187 90000