HP 200 Service Manual page 74

5 Disconnect all 12 cable connectors from the main PCA.
C A U T I O N
0D2 DmbtinJ: Make sure to connect all cables in the correct orientation and to the correct
sockets
Media-axis encoder
Front-panel PCA
Pinch-wheel sensor
Window sensor
Media sensor
Bail sensor
X = Media motor
Y = Carriage motor
6 Remove the five screws that secure the
main PCA to the electronics enclosure.
0D2 DmbtinJ: Temporarily leave the screws
loose; tighten the serial and parallel connector
screws first; then tighten the PCA screws
Torx-10
6 10 Removal and Replacement
Do not force the front panel PCA cable out of its clamp. First pull the
clamp gently towards you to release the cable; then pull the cable easily
out of the clamp.
MAIN PCA
7 Lift the main PCA clear of the plotter.
Carriage PCA
Stepper motor
Fan
Power supply
C3187 90000