Removing the Window Sensor
1 Remove the electronics enclosure
cover D page 6 5.
2 Remove the window D page 6 15.
3 Remove the center cover D page 6 16.
4 Remove the right endcover D page 6 19.
6 Carefully feed the window sensor cable out from the electronics enclosure and from under
the motor assemblies, unclipping it from the holding clips and ferrite.
The ferr te ho der opens from the top
6 24
Removal and Replacement
5 Disconnect the window sensor cable
connector from the main PCA.
0D2 DmbtinJ: Pos t on the cab e correct y
as nd cated Incorrect pos t on ng cou d
cause obstruct on of the cartr dge carr age or
motor gears
Ferrite
Clip
Window-sensor
connector
Clip
C3187 90000