Removing The Front Panel Assembly - HP 200 Service Manual

Removing the Front Panel Assembly

1 Remove the electronics enclosure
cover ' page 6 5.
2 Remove the window ' page 6 15.
3 Remove the center cover ' page 6 16.
4 Remove the right endcover ' page 6 19.
5 Take note of the correct positioning of
the front panel cable for reassembling.
Incorrect positioning could cause
obstruction of the cartridge carriage or
motor gears.
7 Release the front panel cable from its clamp on the main PCA, and from its holding clip on
the right side of the plotter.
Do not force the cable out of its clamp. First pull the clamp gently towards
C A U T I O N
you to release the cable; then pull the cable easily out of the clamp.
Do not release the front panel cable from its clamp on the front panel PCA
Front-panel
connector clamp
6 32 Removal and Replacement
6 Unclip the window sensor cable and
front panel cable from their holding clip
on the underside of the front panel
assembly.
Front-panel
cable
Window-sensor
cable
Clip
C3187 90000