Removing The Right Endcover - HP 200 Service Manual

Removing the Right Endcover

1 Remove the window D page 6 15, and the center cover D page 6 16.
2 Remove the two screws on the right front trim and the two screws on the right back trim.
Torx-15
C A U T I O N
5 Remove the three screws from the right
side of the right endcover.
Torx-15
3 If the plotter is attached to a plotter
stand, loosen the two right hand screws
that attach the plotter to the stand.
C3187 90000
Reassembling: When replacing screws on any plastic part, always begin
by gently twisting the screw in anticlockwise with your hand, until the
screw finds the thread path and clicks, and then twisting the screw in
clockwise with your hand, before using a screwdriver. This is to avoid
cross threading. Do not over tighten the screws.
4 Maintaining an even pressure on the top
and bottom of the endcover, pull it to the
right, away from the plotter.
Do not stress or apply pressure to the
front panel assembly.
Do not let the window pivot spring drop out
of the endcover
0D2 DmbtinJ: Note the upper and lower
grooves the endcover engages on the front
panel
C A U T I O N
Removal and Replacement 6 19