HP 200 Service Manual page 91

7 Remove the screws that attach the
bottom cover to the plotter, and lift the
cover clear of the plotter.
D/A1 size plotters have 8 screws.
E/A0 size plotters have 10 screws.
Torx-20
9 Cut the plastic tie that fastens the
media sensor cable to the underside of
the entry platen.
C A U T I O N
Take care not to cut the media sensor cable
itself.
C3187 90000
8 Pull the media sensor straight out
towards you, freeing it from the
underside of the entry platen.
10 Lift the media sensor and cable clear of
the plotter
Reassembling: Ensure that the two
flags on the media sensor are correctly
positioned (see following procedure).
Plastic tie
Calibration: After having reassembled the
plotter, perform the media sensor calibration
(Details D chapter 7).
Removal and Replacement 6 27