Step 5: Confirm And View Current Amx Usb Device Connections - AMX NXD-700i Operation/Reference Manual

If the G4 panel does not appear, refer to the Troubleshooting section on page 127 for
more information.
12.
The USB icon will appear to the left of the Connection Status icon to signify an active USB connection
(FIG. 30).
FIG. 30
USB icon

Step 5: Confirm and View Current AMX USB Device Connections

Use the CC-USB Type-A to Mini-B 5-wire programming cable (FG10-5965) to provide communication
between the mini-USB Program port on the touch panel and the PC.
This method of communication is used to transfer firmware KIT files and TPD4 touch panel files.
A mini-USB connection is only detected after it is installed onto an active panel.
Connection to a previously powered panel which then reboots, allows the PC to
detect the panel and assign an appropriate USB driver.
1.
Verify this direct USB connection (Type-A on the panel to mini-USB on the panel) is configured properly
using the steps outlined in the previous two sections.
2.
With the panel already configured for USB communication and the Virtual Master setup within NetLinx
Studio, its now time to verify the panel is ready to receive files.
3.
Click the OnLine Tree tab in the Workspace window to view the devices on the Virtual System. The
default System value is one.
4.
Right-click on the System entry (A in FIG. 31) and select Refresh System. This causes a refresh of all
project systems, establishes a new connection to the Virtual Master, and populates the System list with
devices on your particular system.
FIG. 31 Repopulating the System List
NXD-700i & NXT-CA7 7" Modero Touch Panels
Configuring Communication
USB icon
29