System Settings Page - AMX NXD-700i Operation/Reference Manual

Security Profile Features (Cont.)
DoD:
A transition from one security mode to another will reset the Protected/Web Control/
remote login password to the default value for the current security mode (please refer
to the default passwords above). A transition to Secure or DoD mode will disable G4
Web Control. Although the security password features are immediate, a reboot must
occur for all the new security mode features to fully take effect.
For more information on configuring AMX devices for a secure environment, please refer to the guide Security
Profiles: Configuring AMX Devices For Installation Into a Secure Environment, available at www.amx.com.

System Settings Page

The System Settings page (FIG. 55) sets the Secondary DNS Address information with its corresponding IP
communication parameters, NetLinx Master communication settings, and reads the device number assigned to
the Modero panel.
FIG. 55
System Settings page)
The elements of the System Settings page are as follows:
System Settings Page
Back:
Wired icon:
Connection Status icon:
NXD-700i & NXT-CA7 7" Modero Touch Panels
• Default Protected Setup Password is "Amx1234!".
• Minimum password requirement is 8 characters with at least one numeric character, one
uppercase character, one lower case character, and one special character, with no
duplicate adjacent characters.
• Remote login uses SSH.
• Remote login user name is "amx".
• Login failure attempt pauses 4 seconds before another login attempt is allowed.
• After 3 consecutive unsuccessful SSH login attempts, login lockout is enabled for 15
minutes.
• Login and logout audit logging is enabled.
• DoD login banner is enabled.
Saves the changes and returns to the previously active touch panel page.
The icon to the left of the Connection Status Icon displays that the current
connection to the Master is Wired (image of three networked computers).
This visual display of the connection status allows the user to have a current
visual update of the panel's connection status, regardless of what page is
currently active.
• A Lock only appears on the icon if the panel has established a connection
with a currently secured target Master, which requires a username and
password.
Setup Pages and Descriptions
55