Lexmark MS310 Manual page 57

Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide
To Enable/Disable Safe Mode, do the following:
1.
2.
3.
Release the buttons when the splash screen
appears.
Safe Mode
Go to Configuration Menu:
1.
2.
3.
4.
5.
6.
To go to the Restore Point, do the following:
1.
2.
3.
Restore Point
4.
For Training Purposes Only
Turn off the printer.
Press and hold 6 and 7.
Turn on the printer.
***** OR *****
Turn off the printer.
Press and hold 2 and 6.
Turn on the printer.
Go to Safe Mode Menu
Select ON/OFF
POR the printer to take effect
Turn off the printer.
Press and hold 7 and 8.
Turn on the printer.
Release the buttons when the
splash screen appears.
NOTE: Only available for printers
with a code level of EC1 or greater.
Allows print operations to be used even
if a non-critical subsystem failure
occurs. When configured in Safe
Mode, the device operates in a
minimal/base function state for print
operations, permitting a customer to
continue printing until service can be
arranged to repair the device. Safe
Mode is designed to be a short-term
solution.
• Safe Mode state will not disable on
• Safe Mode can co-exist with other
NOTE: Only available for printers
with a code level of EC1 or greater.
NOTE: Not all printers have this
functionality; it is limited to printers
with 4.3"and above Touchscreen.
Restore point is a new functionality
similar to a PC's operating system
restore. In the event that a new
firmware update causes problems in
the printer, the administrator or
customer can roll the printer back to a
previous state.
Important Information:
• Subsequent POR's boot to this
• If new code is flashed, that new
• Only 1 restore point is kept.
• If no code updates have occurred
• Only available on eTask machines.
43
Rev 1.3
POR without holding down the
special button sequence.
POR button sequence modes, such
as Config and Diagnostics.
restore point.
code becomes the boot point.
since the machine was built, there
is no restore point and the key
sequence is ignored.
4/21/2014