Service Menus: Ms410 And Ms412 - Lexmark MS310 Manual

Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide

Service Menus: MS410 and MS412

Several hidden menus exist to configure advanced settings, troubleshoot problems or obtain additional
printer information. The settings contained in these menus should not be changed unless it is
specifically requested by the Service Manual or Technical Support.
improper operation of the printer.
For a complete list of these menus, consult the Service Manual for the printer.
To enter the Diagnostic Menu, do the following:
1.
Diagnostics
2.
Mode
3.
4.
To enter Configuration Menu, do the following:
1.
Configuration
2.
Menu
3.
4.
To enter the Invalid Engine Code state, do the
following:
1.
Invalid
Engine Code
2.
3.
4.
To enter Recovery Mode, do the following:
1.
Recovery
2.
Mode
3.
4.
From a browser, add "/se" to the device IP address.
SE Menu
(Example: http://158.183.3.2/se)
To Enable or Disable Safe Mode, do the following:
Safe Mode
For Training Purposes Only
Turn off the printer.
Press and hold and
Turn on the printer.
Release the buttons when the splash screen
appears.
Turn off the printer.
Press and hold and
Turn on the printer.
Release the buttons when the splash screen
appears.
Turn off the printer.
Press and hold
Turn on the printer.
Release the buttons when the splash screen
appears.
Turn off the printer.
Press and hold and
Turn on the printer.
Release the buttons when the splash screen
appears.
Changing the settings may cause
The Diagnostics Menu contains
advanced settings and operations
.
used for repair, adjustments or
other diagnostic actions.
The Configuration Menu contains a
set of menus, settings and
operations which are infrequently
required by a user.
.
Generally, the options made
available in this menu group are
used to configure a printer for
operation.
This state allows you to POR the
printer into a mode that disables the
Engine Code and allows the
programming of new code into the
Engine card.
.
Typically this function is used to
reprogram defective Engine code
but can be useful in other
applications.
NOTE: Recovery Mode only available
on non-eTask printers.
This mode will allow the printer to
boot from a secondary set of
.
instructions to allow a code flash to
the printer.
While in this mode, you can ONLY
flash code via USB directly
connected to a PC.
Capture diagnostic and debug data.
• Safe Mode state will not disable on
POR without holding down the
32
Rev 1.3
4/21/2014