Service Menus: Mx310/Mx410/Mx51X/Mx61X - Lexmark MS310 Manual

Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide

Service Menus: MX310/MX410/MX51x/MX61x

For a complete list of these menus, consult the Service Manual for the printer.
To enter the Diagnostic Menu, do the following:
1.
Diagnostics
2.
Mode
3.
4.
To enter Configuration Menu, do the following:
1.
Configuration
2.
Menu
3.
4.
To enter the Network SE Menu, do the following:
1.
Network SE
Menu
2.
3.
From a browser, add "/se" to the device IP address.
SE Menu
(for example: http://158.183.3.2/se)
To enter the Invalid Engine Code state, do the following:
1.
Invalid 2.
Engine Code
3.
4.
To enter Recovery Mode, do the following:
1.
2.
Recovery 3.
Mode
4.
For Training Purposes Only
Turn off the printer.
Press and hold 3 and 6.
Turn on the printer.
Release the buttons when the
splash screen appears.
Turn off the printer.
Press and hold 2 and 6.
Turn on the printer.
Release the buttons when the
splash screen appears.
Enter Network/Ports>Standard
Network>Std Network Setup
menu.
Press and hold 6, 7 and 9.
Release the buttons when the
Network SE Menu appears.
Turn off the printer.
Press and hold 3, 4 and 6.
Turn on the printer.
Release the buttons when the
splash screen appears.
Turn off the printer.
Press and hold 2, 7 and 8.
Turn on the printer.
Release the buttons when the
splash screen appears.
The Diagnostics Menu contains
advanced settings and operations used
for repair, adjustments or other
diagnostic actions.
The Configuration Menu contains a set
of menus, settings and operations
which are infrequently required by a
user.
Generally, the options made available
in this menu group are used to
configure a printer for operation.
You do not POR the machine to access
this menu.
Configure or reset advanced Network
settings.
This state allows you to POR the
printer into a mode that disables the
Engine Code and allows the
programming of new code into the
Engine card.
Typically this function is used to
reprogram defective Engine code but
can be useful in other applications.
NOTE: Recovery only available on
non-eTask printers.
This mode will allow the printer to boot
from a secondary set of instructions to
allow a code flash to the printer. No
other functions are available. The
screen will have a red background and
say "Recovery".
While in this mode, you can ONLY
flash code via USB directly connected
to a PC.
50
Rev 1.3
4/21/2014