Removing/Mounting The Top Cover - Fujitsu Primergy N800 Manual

Opening/closing the server
8.1.4

Removing/mounting the top cover

I
It is not necessary to remove the PCI bus hot-plug cover.
Figure 18: Removing the top cover
Ê Turn off all peripheral devices connected to the server.
Ê Shut the server down, turn the server off and disconnect it from the line
voltage.
V
CAUTION!
Turning off the server does not disconnect it from the line voltage. In
order to fully disconnect from the line voltage, you must pull out the
power plug.
Ê Remove the two holding screws.
Ê Push the cover uniformly ca. 2.5 cm in the direction of the arrow to
disengage the row of tabs attaching the cover to the chassis and remove it.
Mounting is performed in reverse order.
88
System expansions
U41243-J-Z156-1-76