Fujitsu Primergy N800 Manual page 38

Connecting devices to the server
1
Figure 11: The PCI CAN bus controller
The CAN bus connector is located on the connection panel of the CAN bus
controller board (inserted into a PCI slot) on the back of the server (see figure 11
on page 30 and figure 13 on page 36).
Optical fiber transmission can be used to bridge longer distances between the
PRIMERGY server and the PRIMERGY S40-DF, i.e. the CAN bus connection
is made via multi mode fiber technology (for further information, see the
documentation for CAN-MMF).
ServerView and the CAN bus
ServerView uses the CAN bus for communication with the clients.
This involves setting up ServerView, including the corresponding agents, in the
group of servers and storage subsystems to be monitored. ServerView can then
receive information on the status of the fans, temperature and other important
system components from all the members in the group (e.g. the storage
subsystem) via the CAN bus. ServerView evaluates this information and edits it
for the administrator (Manager) for display or forwarding. Refer to the
ServerView manual for more information (see "Related publications" on
page 125).
I
A retrofitted PCI CAN bus controller will be identified by ServerView after
an update of the installed ServerView Client only.
30
Installing the server
U41243-J-Z156-1-76