Table of Contents
Advertisement
Utilities
5.4.3
Installing graphic drivers
After configuration the system, you must install graphic drivers in order to fully
utilize the functions of the onboard CL-GD5480 super VGA graphic controller.
Ê The CD-ROM containing the configuration software also contains the
graphic drivers for use under DOS or Windows NT. Read the information on
installing these drivers in the README.TXT file on the CD-ROM.
Ê You will find information on other operating systems in your operating
system instructions for installing device drivers.
5.4.4
QLogic SCSI utility
The QLogic SCSI utility detects the SCSI host adapter on the system board. You
can use this utility to
– change default values
– check and/or change SCSI device settings that may conflict with those of
other servers.
Running the SCSI utility
Ê To start the program, press [Alt]+[Q] when the following message is
displayed on the screen:
Press Alt+Q to start QLogic Configuration Utility ...
5.4.5
Installing PCI hot-plug software
The PCI hot-plug software PCI Hot Plug setup is included on the ServerStart CD
(see also the section "Boards in hot-plug PCI slot" on page 99).
Ê Place the CD in the CD drive and start the setup.exe program.
The setup program copies the PCI hot-plug utility and the corresponding drivers
to the hard disk and makes the necessary registry entries. A new symbol is
added to the Control Panel which you can use to run the PCI hot-plug utility.
72
Configuration software and utilities
U41243-J-Z156-1-76
Advertisement
Table of Contents
