System board components
V
CAUTION!
Ensure to turn the screw clockwise in order to remove it!
Slowly and carefully increase the pressure on the screw until it begins
to turn. The effort when loosing the screw should be as low as
possible.
Otherwise the thin metal bar may break, rendering it impossible to
loosen the screw.
Ê Remove the TPM screw.
Ê Remove the defective TPM on the upper side of the system board.
10.3.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page
57.
Ê Reinstall and secure the server blade in the system unit as described in
section
"Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
234
62.
Upgrade and Maintenance Manual
"Closing the server blade" on
58.
"Closing the rack
BX920 S4