Table of Contents
Advertisement
2
Viewing Etherlike Statistics
STEP 1
STEP 2
13
-
60 Sec—Statistics are refreshed every 60 seconds.
The Receive Statistics area displays information about incoming packets.
•
Total Bytes (Octets)—Octets received, including bad packets and FCS
octets, but excluding framing bits.
•
Unicast Packets—Good Unicast packets received.
•
Multicast Packets—Good Multicast packets received.
•
Broadcast Packets—Good Broadcast packets received.
•
Packets with Errors—Packets with errors received.
The Transmit Statistics area displays information about outgoing packets.
•
Total Bytes (Octets)—Octets transmitted, including bad packets and FCS
octets, but excluding framing bits.
•
Unicast Packets—Good Unicast packets transmitted.
•
Multicast Packets—Good Multicast packets transmitted.
•
Broadcast Packets—Good Broadcast packets transmitted.
To clear statistics counters:
•
Click Clear Interface Counters to clear counters for the interface displayed.
•
Click View All Interfaces Statistics to see all ports on a single page.
The Etherlike page displays statistics per port according to the Etherlike MIB
standard definition. The refresh rate of the information can be selected. This page
provides more detailed information regarding errors in the physical layer (Layer 1),
which might disrupt traffic.
To view Etherlike Statistics and/or set the refresh rate:
Click Status and Statistics > Etherlike.
Enter the parameters.
Cisco Small Business 200 Series Smart Switch Administration Guide
Status and Statistics
Viewing Etherlike Statistics
Advertisement
Table of Contents
