Chapter 6 — Enable Screen Blanking
Install Switch for Screen Blanking
Enable Screen Blanking
86
Sample Custom Serial Cable for Switch
Pin 8
Pin 7
This section explains how mount, connect, and enable the switch for
screen blanking.
1 Using your own mounting hardware, secure the switch sensor to
the vehicle.
2 Connect the serial cable to the switch. Make sure that Pin 7
connects to the switch connection and Pin 8 connects to the other
terminal.
Pin 8 Pin 7
3 Connect the serial cable to the COM 1 or COM 2 port on your
computer.
After you have wired and mounted the motion switch sensor, you must
enable screen blanking in Intermec settings on the vehicle mount
computer.
1 In Intermec Settings, select Device Settings > Screen >
Screen Blanking on Motion.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Manual