Troubleshoot Reading Bar Codes - Intermec CV41 User Manual

Troubleshoot Reading Bar Codes

Problems Reading Bar Codes
Problem
You cannot see the illumination
beam or frame from the scanner
when you press the Scan button
and aim the imager at a bar code
label.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Manual
4 Tap the Diags tab to run a ping test to the host.
a In the text field, enter the IP address of the host.
b Tap Start Ping. The graph shows the amount of time it takes
for the host to return the ping.
5 Tap the Global tab to view the global property values of the Wi-Fi
connection.
Use this section to troubleshoot problems that may prevent you from
being able to read a bar code with an Intermec scanner. If you cannot
find the solution in the following table, refer to your scanner user
guide for more information.
Solution
•
You may be too far away from the bar code label. Try moving
closer to the bar code label and scan it again.
•
You may be reading the bar code label "straight on." Change
the reading angle and try again.
•
The imager hardware trigger might be disabled in Intermec
Settings. To check the setting go to Intermec Settings and
select Data Collection > Scanner Settings. Hardware
trigger should be checked.
Chapter 7 — Troubleshoot and Maintain the Computer
93