Displaying Ipx Interfaces; Defining An Ipx Interface - 3Com LANPLEX 2500 EXTENDEDPLEX®2500 EXTENDED User Manual

Displaying IPX
Interfaces
Top-Level Menu
system
ethernet interface
fddi route
display
atm
server
define
bridge
forwarding
modify
ip
rip
remove
enhanced
ipx
sap
appletalk
statistics
snmp
analyzer
script
logout
IPX forwarding is enabled, RIP is active, SAP is active.
Index
1
2
3
Defining an IPX
Interface
Top-Level Menu
system
ethernet interface
fddi display
route
atm
server define
bridge forwarding
modify
ip
rip
remove
ipx enhanced
sap
appletalk
statistics
snmp
analyzer
script
logout
You can display a table that shows all IPX interfaces and their parameter
settings configured for the system.
To display IPX interface information:
From the Administration Console top-level menu, enter:
ipx interface display
As shown in the following example, the current configuration is
displayed. It contains IPX forwarding, RIP, and SAP information for the
system as well as IPX interface information.
IPX address Cost
45469f30
5d41a110
6d321a22
When you define an interface, you define the interface's IPX address,
cost, format, and the associated IPX VLAN index.
You must define an IPX VLAN before you define the IPX interface to
associate with that VLAN.
To define an IPX interface:
1 From the Administration Console top-level menu, enter:
ipx interface define
You are prompted for the interface's parameters. To use the value in
brackets, press [Return] at the prompt.
2 Enter the IPX network address of the interface.
3 Enter the cost of the interface.
4 Enter the format of the interface.
5 Enter the index of the IPX VLAN associated with this interface.
Administering Interfaces
Format State
1 802.2 Up
1 802.2 Up
1 802.2 Up
11-3
VLAN index
2
1
4