Removing The Default Route; Administering The Arp Cache - 3Com LANPLEX 2500 EXTENDEDPLEX®2500 EXTENDED User Manual

Top-Level Menu
system
ethernet
interface
fddi display
route
static
atm
arp
remove
bridge
atmArpServer
flush
ip
multicast
default
ipx
udpHelper
noDefault
appletalk
routing
snmp
icmpRouterDiscovery
analyzer
rip
script
ping
logout
statistics
Removing the
Default Route
Top-Level Menu
system
ethernet
interface
fddi
route display
atm
arp static
bridge
remove
multicast
ip
flush
atmArpServer
ipx
default
udpHelper
appletalk
routing
noDefault
snmp
icmpRouterDiscovery
analyzer
rip
script
ping
logout
statistics
Administering
the ARP Cache
To statically configure the default route:
1 From the top level of the Administration Console, enter:
ip route default
2 Enter the gateway IP address of the route.
The default route is immediately added to the routing table.
To remove a default route, enter the following command string from the
top level of the Administration Console:
ip route noDefault
The default route is immediately removed from the routing table.
The LANplex system uses the Address Resolution Protocol (ARP) to find the
MAC addresses corresponding to the IP addresses of hosts and routers on
the same subnets. An ARP cache is a table of known IP addresses and their
corresponding MAC addresses.

Administering the ARP Cache

9-13